Knape & Vogt PRC12-2-27-R-W Guide d'installation télécharger pdf

Place sliding base assembly on cabinet floor, in desired position. Position front

Mounting Strap against the back edge of the cabinet face frame. If installing in a

frameless cabinet, measure 1/2˝ to 3/4˝ back from front of cabinet opening, and

align sliding base assembly parallel to cabinet opening. Close door to make sure

the assembly will not hold cabinet door open. Also, check to see if unit will clear

the door opening when fully extended. Once position is determined, fasten in

place using four mounting screws provided and a Phillips head screwdriver.

Optional Step:

Mark placement of mounting holes with a pencil, remove sliding base assembly

and drill pilot holes for fastening screws. Place sliding base assembly back into

position and fasten with the provided screws.

If sliding members are fully extended, close unit so that the rear cage clip retainer–

built into the side of the sliding members–are inside the cabinet. Beginning with the

rear-most wire cage, hold the cage over the sliding base assembly so that the

cage aligns with the clip retainer. The orientation of your bins is demonstrated in the

top view chart below. Pushing firmly, lower wire cage into clip retainers until fully

seated. (NOTE: Never install wire cage(s) when slides are extended.) Close unit

completely and install front-most wire cage in the same manner. Insert bins into

cages, place lids on top of bins (if supplied) to complete the installation. If your unit

did not come pre-packed with lids and you would like lids, visit www.kv.com to

purchase the lids you require.

Parts Included

A. Waste Bins (2)

B. Wire Cages (2)

C. Sliding Base Assembly (1)

D. Mounting Screws (4)

E. Lids (if supplied)

Tools Required

• Phillips Head Screwdriver

Optional

• Drill with 1/16˝(1.5mm) bit for

drilling pilot holes

• Pencil

Product Assemblies

PSW15-2-20

PSW15-2-35

PRC12-2-27

SLIDING DOUBLE WASTE BINS

Installation Instructions

310163-0609

Inspect all parts and read all instructions prior to

beginning assembly and installation.

Top View

Double Bin

BIN

PSW15-2-20

PSW15-2-35

PRC12-2-27

Overall

Cabinet Width:

15" & 18"

2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA

800.253.1561 • 616.459.3311 • www.kv.com

reserves the right to change speciﬁ cations without notice. Made in USA.

Clip

Retainer

Mounting

Straps

Sliding

Members

BIN

1 2

SLIDING DOUBLE WASTE BINS 1

Résumé du contenu

Page 1 - SLIDING DOUBLE WASTE BINS

Place sliding base assembly on cabinet floor, in desired position. Position front Mounting Strap against the back edge of the cabinet face frame. If i

Page 2

Notice de MontageInspectez toutes les pièces et lisez toutes les instructions avant de procéder à l'assemblage et à l'installation.Étape 1Pl

Commentaires sur ces manuels

Pas de commentaire

Knape & Vogt PRC12-2-27-R-W Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Knape & Vogt PRC12-2-27-R-W. Knape & Vogt PRC12-2-27-R-W Installation Guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Knape & Vogt PRC12-2-27-R-W